Which shows an example of a single replacement reaction

Explanation:

Answer- D(Earth's spin)

Answer:

2

Explanation: the grass and soil is the most botherd

The areas where soil erosion is likely to occur is 2.

Soil erosion is defined as phenomenon by which the soil is detached from the land and resulting in the deterioration of the soil.

Here,

The soil erosion occurs due to the impacts of water and wind on the soil, that is because of heavy wind and rain, soil is removed away.

Also the over utilization of land for farming can also cause soil vulnerable for erosion.

In the areas were more trees are present, the soil is held firmly on the land with the help of the root of these trees.

Therefore, we can say that land areas having only fewer amount of trees are more vulnerable to soil erosion. The area 2 shows the presence of very lesser trees.

Hence,

The areas where soil erosion is likely to occur is 2.

To learn more about soil erosion, click:

https://brainly.com/question/29091356

#SPJ5

Answer:

there faster

Explanation:

stronger,wiser,better,THEY ARE BETTTEEEEEEEERRRRRRRR

Answer:

they're so strong that they don't need to lift heavy weights anymore because they're experts (slay lol). so they just have a simple daily workout.

To find the volume of the block, subtract the initial water volume from the final water volume, convert the change in water volume to cubic centimeters, and consider it as the volume of the block.

To find the volume of the block using the measurements provided.

1. Calculate the change in water volume:

The initial water volume is given as 62.3 mL, and the final water volume is given as 89.5 mL. To determine the change in water volume, we subtract the initial volume from the final volume: 89.5 mL - 62.3 mL = 27.2 mL. This value represents the increase in water volume caused by placing the block in the graduated cylinder.

2. Convert the change in water volume to cubic centimeters:

Since 1 mL is equivalent to 1 cubic centimeter (cc), we can directly convert the change in water volume from milliliters to cubic centimeters. In this case, the change in water volume is 27.2 mL, which is also equal to 27.2 cc.

3. Determine the volume of the block:

When the block is placed in the graduated cylinder, it displaces some amount of water, resulting in an increase in water volume. By measuring this increase in volume, we can determine the volume of the block itself. In this case, the change in water volume of 27.2 cc represents the volume of the block.

By following these steps, we can find the volume of the block based on the provided measurements.

Therefore, By deducting the initial water volume from the final water volume and converting the difference in water volume to cubic centimeters, the block's volume can be calculated. the volume of the block is 27.2 cc.

To learn more about measurements click:

https://brainly.com/question/28109798

#SPJ1

Answer:

C. Beats

Explanation:

When waves are interfering with each other, the sound is louder in some places and softer in others. As a result, we hear pulses or beats in the sound.

Answer:

beats

Explanation:

got it right

Answer: A

Explanation:The Pawn moves directly forward, never backward or to the side. Pawns capture a piece that is one square diagonally forward. Though Pawns normally cannot move diagonally, this is the only way they capture.

Based on the information provided, the best move to capture a hanging piece would be: A) Nxg3

Nxg3 would be the best move to capture a hanging piece.

This move involves sacrificing the knight to capture the hanging piece, which could be a bishop or pawn, depending on the position of pieces. After Nxg3, the opponent may capture the knight with different piece, but the player who made the move will have successfully captured the hanging piece.

However, it's important to note that the best move ultimately depends on the overall strategy of the player and the position of the other pieces on the board.

To know more about chess, refer

https://brainly.com/question/1401793

#SPJ1

Answer:

By gathering plants, fishing, and hunting or scavenging wild animals. They used knapped stone tools, and also used wood and bone tools. Please vote Brainliest!

Explanation:

Answer:

The difference is that applied force is applied onto a person or another object but normal force, is the support force exerted upon an object that is in contact with another stable object.

Explanation:

Answer:

mass x gravity x height

Explanation:

Gravitational potential energy is measured in jules

The faster an object is going, the more resistance there will be. An example of this would be if you're running the faster you run, the more air is going against you.

I hope this helps!

Answer:

I think B is the answer.

Answer: (B) 4 Seconds

Explanation: The Balance of weight and air resistance equals out after 4 seconds giving you your terminal velocity. (the fastest speed you can travel at your given weight and air resistance)

Answer : B. The sjydriver has the fastest speed at 4second.

What is air resistances ?

--Air resistance is a type of friction force.

-- Air resistance, there are not two solid surfaces in contact.

-- Air resistance is the frictional force acting on an object and the air around them.

--This means that friction always pushes in the opposite direction than the skydiver is travelling, therefore slowing the skydiver down.

Concept Used

-- When the skydiver jumps off the plane, their speed would accelerate because the pull of gravity on the person, or their weight force, is greater than the air resistance slowing them down.

-- A person’s weight force will always stay the same.

-- The weight force of the person will equal their air resistance.

-- This would make the skydiver travel at constant speed.

--To travel at constant speed forces have to be equal to zero.

--This constant speed is called terminal velocity

Learn more about terminal velocity from https://brainly.com/question/8351585

#SPJ1

Answer:

It is the 3 one

Explanation:

The first illustration represents high accuracy but low precision, therefore the correct answer for the given problem is option A.

The degree to which a measurement is accurate in relation to its true value. The degree to which the same results are produced by repeated measurements under the same circumstances is known as precision.

Scientists think of errors in terms of precision and accuracy. How accurately a measurement reflects how close it is to the actual or acceptable value. Precision is the degree to which measurements of the same thing concur with one another.

The first illustration represents high accuracy but low precision

The second illustration represents high accuracy but high precision

The third illustration represents low accuracy but high precision

The fourth illustration represents low accuracy but low precision

Thus, The first illustration represents high accuracy but low precision, therefore the correct answer for the given problem is option A.

Learn more about accuracy here

https://brainly.com/question/13099041

#SPJ5

Answer:

50 :)

Explanation:

Answer:

synthesis

Explanation:

Answer:

C

Explanation:

velocity = displacement (m) / change of time (s)

velocity = (400 + 300) / (100 + 400)

velocity = 1.4 m/s

Answer:

Net force

I think it’s balanced force

The greater the altitude, the greater the potential energy.

Highest Potential energy

Lowest Potential Energy

Answer:  

1) A person in an airplane

2) Position A on a roller coaster

3) Position C on a roller coaster

4) Position D on a roller coaster

5) Position B on a roller coaster

6) A person standing on the ground

Explanation:

All in that order. : )))

Answer:

Rocket Center of Gravity. As a rocket flies through the air, it both translates and rotates. The rotation occurs about a point called the center of gravity. The center of gravity is the average location of the weight of the rocket.

Answer:

When forces are balanced, an object is in Equilibrium.

Explanation:

If forces acting on the object is balanced then the object will be in equilibrium and it will not have any acceleration.

Answer:

Explanation:

1 matter

2 the chain / air pressure  

3 gravity

4 in the cup

5 inertia

6 pushed or pulled

7 rest

8 motion

9 mass

10 reaction

11 b

12 a

13 grams

14 listen to the song

Answer: Explanation:

Plants and animals each produce the gases that the other needs to live. Plants need carbon dioxide—people and other animals exhale carbon dioxide as a waste product. People and other animals need oxygen—plants produce oxygen during an important process called photosynthesis, which turns the sun's energy into nutrients.

Answer:

During your what ?

Explanation:

You should be kept at the same distance during your what?

Answer:

B

Explanation:

It the same amount of force is being used it will cancel each other out.